PCBA Special Reminders
Unused and excessive parts supplied by you or purchased by us will not be returned by default. If you want the parts to be sent back to you with the assembled boards, please contact your sales representative or make a note on your related order, and let us know which parts to send.
oAll items must be on a continuous strip or reel
oIf you need to assemble the same SMT part in different boards, do not cut them into strips, please keep them in the continuous strip of tape or on the reels.
oSpecial instructions must be provided if components need special handling such as no clean solder
oBulks or Trays are okay for THT
oAvoid order tubes but if any SMD is in tube it must be a full length
o0201 to 0603 size: Minimum extra quantity 50 plus required quantity
o0805 and above size: Minimum extra quantity 20 plus required quantity
oDiodes, Triodes, Crystal oscillator etc SMD components 2 extra parts needed
oIC, BGA, QFP, QFN,Connectors and other expensive components, no need extra quantity
oIC, BGA, QFP, QFN,Connectors and other expensive components, no need extra quantity
oChip components, 0.5% overage;
oDiodes, Triodes, 0.1% overage is needed;
If you choose JH PCBA turnkey PCB assembly service, we source all components for you according to BOM. We try our best to keep these components as accurately similar to the components listed in BOM. We will notify and seek approval from customers before making substitutions for components.
All Printed Circuit Boards must have fiducial marks.
Your PCB length and width must be at least 2 inches (approximately 50mm). If your individual PCB is smaller than 2 inches you should panelize your boards. Our support team is available to assist if you need help.
Components should be at least 0.120 inches (3mm) from board edge. If components are closer or overhang the board edge then borders will be required. When components are close to the edge we prefer tab routs with mouse bites instead of V-scored panels